• English
  • French

µScoop firmware update

Please read carefully the following instructions before proceeding with the update.

Important notice: if the current version (before updating) is older than version 1.04:

  • If a password is set for accessing the html pages, you MUST reset it to a blank value (refer to page Maintenance/Login data), BEFORE performing this firmware update. You can set a password again once the update is completed.
  • After the update, you may meet display issues on the html pages of the product. This will be solved by clearing the cache of the html browser.

The unit should be connected on the same LAN as a computer, from which you will use a web browser in order to perform the firmware upload to the codec.

  • Download the update file (see link below).
  • Open the html page of the unit, go to the "Maintenance" tab, " System Update".
  • From this page, click “Browse…”, search and select the update file.
  • Click the “Update” button. The process starts.
  • Wait for the end of the process. The displayed text is then “Rebooting” on the web page.
  • At this stage the unit normally reboots by itself. If this does not take place automatically, and the unit stays in this state, switch it off, and then back on.
  • In some cases the following reboot phase may last longer than usual.
  • Check on the web interface that the new version has been installed successfully.

The update does not clear the settings done before the update process. However, AETA cannot guarantee in all situations that the codec will operate accurately with these settings unchanged.
In doubt, we thus recommend to bring the unit back to its “factory” default settings.

Firmware revision history (click a version for details)

Version 1.05

Version 1.05

Released 2017/11/13            Click here to download the update file
Changes from previous version:

New features :

  • Added support for the "Remote Assistance/Access" service. The settings for this service are accessible on the "Maintenance" page of the html interface, and its current state is visible on the "Status" page.
Version 1.04

Version 1.04

Released 2017/09/13            Click here to download the update file
Changes from previous version:

Important notice: if a password is set for accessing the html pages, you MUST reset it to a blank value (refer to page Maintenance/Login data), BEFORE performing this firmware update.
Once the update is completed, you can later set a password again.

Web pages security improvements :

  • Implementation of HTTPS for the embedded server.
  • Enhanced protection against attacks.
  • Implemented a technique to prevent from Cross-Site Request Forgery attacks.

Improvements :

  • When importing a configuration file, the login password is not affected (previously, the password possibly included in the configuration file was also imported).
  • Opus coding is upgraded to version 1.2.1.
Version 1.03.01

Version 1.03.01

Released 2017/04/19          Click here to download the update file
Changes from previous version:

Improvements:

  • Detailed statistics of the AoIP transmission displayed on the "Connections" page of the html interface.
  • Improved handling of SIP call redirection.
Version 1.03

Version 1.03

Released 2016/11/09          Click here to download the update file
Changes from previous version:

Fixed issues :

  • GPI not operative when configured for redialling or releasing the link: fixed.
Version 1.02.01

Version 1.02.01

Released 2016/08/29          Click here to download the update file
Changes from previous version:

Fixed issues :

  • Default route deleted from the routing table after editing the Ethernet parameters, leading to loss of control from a remote network: fixed.
Version 1.02

Version 1.02

Released 2016/08/04          

Improvements :

  • All the LEDs flash briefly during startup.
  • The "Ready" and "Dec" LEDs blink red during the firmware update process (update from version 1.02).

To top

Version 1.01

Version 1.01

Released 2016/08/02
First release

To top

< BACK